WERY - hammer mills

 

are accepted and approved crushing machines

for bricks, potsherds, pumice, coal, coke, cinder, half-hard tuff, quartzite, clay, raw lime, sandstone to sand, glas and other soft and half-hard minerals, also for bones, meat and bone meal, horns, wood, bark etc.

Milling range according to the amplitude of the split-grate grain size 0-25 mm or larger

 


Powerful and efficient
Multi-purpose applications
Robust construction, low maintenance


Construction:

Enclosure in heavy robust sheet steel-electrowelded construction (also in stainless steel)


Milling space with exchangeable high-carbon steel armour plates and beating arms


Upper enclosure folding, easy access to all parts of the machine


Large dimensioned sledge hammers

swinging hanged up on the turning arbor of the hammer shaft, made of wear-resistant, alloyed special steel, to use on 4 impact edges



Type WH 75/60 steady state with extracted split-grate

Split-grate made of high-carbon steel (flat or conical), easy to exchange, easy adjustable to another amplitude of the split -grate.
Higher adjusting of the split- grate, therefore maximum utilisation of the sledge hammers and constant hourly output.

The large dimensioned rotor with main shaft is supported on both sides in dustproof bearings.
The machine has drive pulley and fly wheel. All types may be delivered with wagon (rigidly coupled or centre pivot plate), pulling tool and motor drive.

type hourly output power rating revolutions per minute
Typ WH 45/30
Typ WH 45/50
Typ WH 60 40
Typ WH 60/50
Typ WH 75/60
Typ WH 75/80
Typ WH 90/60
Typ WH 90/100
Typ WH 130/100
Typ WH 130/150

ca. 1 - 1,5 cbm
ca. 2 - 3 cbm
ca. 3 - 3,5 cbm
ca. 4 - 5 cbm
ca. 7 - 8 cbm
ca. 10 -12 cbm
ca. 12 -14 cbm
ca. 14 -16 cbm
ca. 50 - 70 cbm
ca. 50 -100 cbm

ca. 6 PS
ca. 12 PS
ca. 15 PS
ca. 15 - 20 PS
ca. 25 - 30 PS
ca. 40 - 50 PS
ca. 60 -100 PS
ca. 80 -120 PS
ca. 100 -150 PS
ca. 150 -200 PS
ca. 900
ca. 900
ca. 800
ca. 800
ca. 600
ca. 600
ca. 600
ca. 600
ca. 600
ca. 600

Hourly output according to hardness of the feed and final fineness.

- More information on hammer mills
- Hammer mills with water-cooled rotor shaft

Ludwig-Wery GmbH Maschinenfabrik, Kaiserstrase 58-60, 66482 Zweibrücken, fon +49 (0)6332/3345, fax +49 (0)6332/17506

 

E-mail info@wery-gmbh.de